These gains are approximate and WILL vary in your model, depending on your chosen servo’s speed, length of servo arm and other factors. These offer two banks, each with individually programmable settings. Roll axis: Uses ailerons for roll and only 10% added Taileron movementįull Flap: Uses approximately 2mm up elevator (measured from the front)Įlster Jet recommend the use of the gyro systems by Powerbox-Systems. Dieser Freischaltcode muss Ihnen bergeben werden. Ihr Ehegatte / Lebenspartner erhlt anschlieend einen Freischaltcode per Post an die aktuelle Meldeadresse. und des Geburtsdatums eine Abrufberechtigung zu beantragen.
Elster online datenabruf full#
Measured with empty main tank, full UAT, landing gear down.Įven though this model can easily be flown as a conventional setup, the configuration used by Elster Jet for 3D flying is as follows: Sie haben dort die Mglichkeit unter Angabe der IDNr. Once comfortable with the model and gyro turned on, slowly take back to 17cm Measured from the leading edge of the elevatorġ8cm forward of the front of the wingtube *Please note that the correct “center” position for the elevator not when it is level! Correct center position is when it is trimmed up 35mm from level. Elevator: 55mm up / 55mm down (measured from the front).Servo arms: Pilot-Rc 1.6″, 1,2″ and 0,8″ Aluminium arms (included with Pilot-Rc servos).Servos: Pilot-Rc PW28AH for aileron and vector.Servos: Pilot-Rc PW48AH for elevators, rudder & flaps.X1 medium size servo for steering (size: 35x15x30mm)Īlso requires all the usual accessories such as transmitter, receiver, batteries, powerbox and possibly other small accessories. Servos: Total x10 (x9 standard size + x1 medium size) 200-260N for 3D vector flight – Avoid high speed, high G flying.
Elster online datenabruf plus#
Includes all the above, plus x10 Pilot-RC servos, all pre-installed. Includes Pilot-RC electric retracts and electric brakes, specific for this model.Īlso available: Turbine Ready version.